Samsung Ubigate iBG2016, Configuration Manual

Page: 75 / 744

Ubigate iBG2016 Configuration Guide/Ed.00
© SAMSUNG Electronics Co., Ltd.
41
Module Configuration
This section describes how to configure serial interfaces of HSSI-1 and WTE-
4S modules.
Configuring V.35
This section describes how to configure a serial interface, V.35. The other
serial interfaces such as RS-232, X.21, 449 and 530 are to be configured in the
similar way.
Configuring V.35 as a DCE
The following figure illustrates a connection of Ubigate iBG2016 configured
as a DCE.
Configuring Step
Step Command Purpose
1 Router# configure terminal Enters the terminal configuration
mode.
2 Router/configure# module serial
[slot /port] Selects a port to configure as a
serial module.
3 Router/configure/module/serial([slot/
port])# mode V.35
Selects a serial interface as a V.35.
4 Router/configure/module/serial([slot/
port])# V35
Enters the V.35 interface.
5 Router/configure/module/serial([slot/
port])/V35# mode dce
Selects V.35 mode as a DCE.
6 Router/configure/module/serial([slot/
port])/V35# clock_rate {56,000 to
52,000,000}
Selects a clock rate.
7 Router/configure/serial([slot/port])/V
35# clock_source {internal | line}
Selects a synchronization clock
source. As a DTE, the option,
‘internal’ , is recommended.
8 Router/configure/serial([slot/port])/V
35# crc {16 | 32}
Selects a CRC mode.
9 Router/configure/serial([slot/port])/V
35# data_mode {normal | inverted}
Selects a data mode.