Samsung Ubigate iBG2016, Configuration Manual

Page: 534 / 744

CHAPTER 5. Analog Voice Port
480
© SAMSUNG Electronics Co., Ltd.
(Continued)
Step Command Purpose
9 timing digit timer-value specifies the DTMF digit signal duration
10 timing guard-out timer-value (FXO ports only) specifies the duration in
miliseconds of the guard-out period that
prevents this remote port detects a
desconnect signal
11 no shutdown Change shutdown Status of voice-port to in-
Service
12 exit Exits voice port configuration mode
13 dial-peer voice {pots | voip}
tag
Example)
/configure# dial-peer voice
pots 11
Enters dial-peer configuration mode and
defines a local dial peer that connects to a
POTS interface.
The
number argument is one or more digits
identifying the dial peer. Valid entries are from
1 to 10000.
The
pots keyword indicates a dial peer using
basic telephone service.
14 destination-pattern WORD
Example)
/configure# voice-port>
destination-pattern 1004
Setting Destination-pattern
Matches dialed digits to a telephony device.
The
string argument is a series of digits that
specify the E.164 or private dialing plan
telephone number.
Valid entries are the numbers 0 through 9 and
the letters A through D.
You can also enter the following special
characters:
- The asterisk (*) or pound sign (#) on
standard touch-tone dial pads can be used
anywhere in the pattern.
14 - The period (.) acts as a wildcard character.
When the timer(T) character is included at the
end of the destination pattern, the router
collects dialed digits until the interdigit timer
expires(5 seconds, by default) or until you dial
the termination character(the default is #). The
timer character must be a capital T.
15 port slot/subslot/port Maps the dial peer to a specific Port Number
16 exit Exits voice dial-peer configuration mode