4 .4
When the AWRT10RF Thermostat has
found all controllers in the network, it
will display the default relay controller
value (1) and the default zone value (1) .
If there is more than 1 relay controller on
the network, the left value
will
flash . If there is only one relay controller
on the the right value
will flash .
Step 8. Use the and
keys to change the
CONTROLLER value, then
the or key to switch to
the ZONE .
Step 12. Press the key to exit
parameter setup and go to the Home
Screen . The display shows the current
date & time, target temperature,
relative humidity, network/internet
status and room temperature .
The AWRT10RF Thermostat
will enter parameter setup
mode, starting with parameter
P 01 . The current device type
along with the Zigbee channel
number will be displayed .
Once the AWRT10RF Thermostat has joined the network, SCANNING-
- - is displayed with a 10-minute countdown timer showing the time
allowed to find all the relay controllers on the network
Step 9. Use the and
keys to change the ZONE
value, then press SELECT .
The AWRT10RF Thermostat
will then display
PAIRING- - - as it associates
with the selected
controller and zone
When paired, RLY_CTL
PAIRED will be displayed
briefly along with the
CNTRLR value and
ZONE value .
Section 4
AWRT10RF Pairing with
Internet Connection (SG888ZB Gateway)
Summary of Contents for AX10RF
Page 1: ...Wireless Controls System Guide As of December 31 2018...
Page 4: ......
