4 .1
AWRT10RF Pairing with
Internet Connection (SG888ZB Gateway)
DEVICE
MODEL(S)
DISPLAY
Relay Controller
AKL01PRF
AKL04PRF
AKL06PRF
AKL08RF
Radiator Valve
ARV10RFM-3
AVA10M30RF
Receiver (RX1)
AX10RF (RX1)
Receiver (RX2)
AX10RF (RX2)
After the initial boot up sequence on the initial power up, the AWRT10RF immediately enters the
pairing process . Using the and key to select between the following devices:
Pairing with AKL01/04/06PRF
and AKL08RF Relay Controllers
To connect the AWRT Wireless Radiant Thermostat and other components using an SG888ZB Gateway,
the gateway must be installed and activated. Please see the
SALUS SG888ZB Installation Instructions
(https://www.salusinc.com/wp-content/uploads/2017/10/BZG_IUG-ENv4.pdf)
for information about
setting up the gateway.
Before pairing, the AKL Series Relay Controller and optional AX10RF Receiver (if desired) must be
installed and powered in accordance with installation instructions included with these devices .
• The LED ring on the SG888ZB Gateway should be solid blue
• The Network Status LED on the AKL Relay Controller should be flashing
• If an AX10RF Receiver is used, the LED backlight on the Auto/Manual switch of this device
should be flashing red and the switch should be in the Auto position
Step 1. If
is not
displayed and flashing, use the or
keys to display it . Press the SELECT key
on the AWRT10RF Thermostat .
The display will show JOINING- - - with a 10 minute
countdown timer to show how much time is
available to complete the next steps . The icon will
flash at the bottom of the screen indicating that the
thermostat is searching for a network to join .
Section 4
Summary of Contents for AX10RF
Page 1: ...Wireless Controls System Guide As of December 31 2018...
Page 4: ......
