3 .4
Device Installation
Step 1. Ensure that all required parts were included in the package .
Step 2. Remove
the AWRT10RF
Thermostat from the
backplate by lifting
the tab in the top
center and sliding the
base downward .
Step 3. Connect an
external 10 kΩ sensor
(AFTS30M sold separately)
if desired cable to the
gateway only, making
sure it is within reach
of a router or ethernet
connection
Step 4. Secure the backplate
to the wall using the provide
screws and wall anchors
FOR BEST RESULTS, ensure that the AWRT10RF Thermostat backplate is level,
using the integral bubble level, when mounting it. NOTE THE ORIENTATION
ARROW molded into the backplate indicating correct orientation.
Step 5. Open
the battery
compartment
Step 6. Remove
the battery tab to
power the AWRT10RF
Thermostat
Step 7. Close
the battery
compartment
Step 8. Attach the AWRT Thermostat by
positioning it against the backplate and
sliding downward .
The AWRT Thermostat can be removed by
gently pushing the latch at the top of the
thermostat and sliding the thermostat upward.
Section 3
Summary of Contents for AX10RF
Page 1: ...Wireless Controls System Guide As of December 31 2018...
Page 4: ......
