978-922-1832
●
www.sagescience.com
●
BluePippin Operations Manual 460013 Rev F
4-2
Setting up the BluePippin
1. Remove the accessory box located on inside edge of box at the front end of the
instrument. Remove the keyboard, mouse, and instrument power supply from their
packaging.
2. Firmly grip both sides of the instrument and lift it from the foam packaging insert. The
BluePippin weighs approximately 14 lbs
.
Place the Pippin on a table or bench top.
3.
Remove the computer monitor from the manufacturer’s box and connect the monitor to
BluePippin using supplied video cable.
4. Connect monitor to power using power supply supplied with monitor.
5. Insert USB connector from computer keyboard into port located in the back of the
Instrument.
6. Connect mouse to BluePippin via USB or PS2 connector at back of instrument.
7. Connect monitor cable into the video port located in the back of the instrument.
8. Connect BluePippin instrument to power via supplied power supply and cable. Power
connector is at rear of instrument.
9. Press power switch located on the rear of the instrument, and wait for software to launch
(approximately 30 seconds).
The BluePippin is ready for use. After the power switch is activated, the
software will launch
– allow ~30 seconds.
Figures 4.1 and 4.2
on the next page show the rear panel of the BluePippin.
Figure 4.3
on the following page shows the front panel.