RTS DKP-4016, Technical Manual

Page: 235 / 282

DKP-4016 DKP-4016 Menu System 235
Bosch Security Systems, Inc. Technical Manual F.01U.308.248 Rev. 03
To configure the OKP’s device name , do the following:
1.
Starting at the Service|OMNEO Setup menu, select OKP .
2.
Press the SEL button .
Device Name, DHCP, and IP Parameters appear in the panel display .
3.
Using the arrow buttons,

select Device Name .
The name of the OKP card appears in the panel display with the first character of its name blinking .
4.
Using the up and down arrow buttons or the Aux shaft encoder, select a new character at the current position .
5.
Using the left and right arrow buttons or the Main shaft encoder, move to the next or previous character position .
6.
Press SHIFT to insert a character at the current position.
7.
Press the SEL button .
OR
Press the
AUX shaft encoder to move to the next character.
NOTE: Press BACK or press the MAIN shaft encoder to cancel editing. A confirmation is required.
8.
Press FWD or move to the end of the name and Press the SEL button (or the AUX shaft encoder) to save changes.
9.
Repeat steps 7 and 8 until you have modified the device name.
10.
Press FWD .
The message Save Name? appears on the panel display.
11.
Press the SEL button .