RTS DKP-4016, Technical Manual

Page: 181 / 282

DKP-4016 DKP-4016 Menu System 181
Bosch Security Systems, Inc. Technical Manual F.01U.308.248 Rev. 03
Filters
Filters allow you to add a bandpass filter, a preset frequency response (equalization) filter or a notch filter to one (1) or more
audio sources.
Bandpass
The Bandpass menu is used to enable using bandpass filters as well as set a low and high frequency range where
frequencies within the two (2) frequency points are passed and anything outside of the range is rejected.
To configure a bandpass range for Inputs , do the following:
1.
Starting at the Audio Options|Advanced|Filters menu, select Bandpass .
2.
Press the SEL button .
Inputs and Outputs appears in the panel display.
3.
Using the arrow buttons, select Input .
4.
Press the SEL button .
Aux 1, OMNEO 1, and OMNEO 2 appear in the panel display.
Or if the AUDIO package has been purchased, OMNEO 1-8 displays
5.
Using the arrow buttons, select either Aux 1 , OMNEO 1 or OMNEO 2 (or OMNEO 1-8, if the audio package is
purchased).
6.
Press the SEL button .
Frequencies and Mode appear in the panel display.
7.
Using the arrow buttons, select Mode .
Disabled and Enabled appear in the panel display .
8.
Using the arrow buttons, select Enabled .
9.
Press the SEL button .
An arrow appears next to the selected option .
10.
Press the CLR button.
Frequencies and Mode appear in the panel display .
11.
Using the arrow buttons, select Frequencies .
12.
Press the SEL button .
The Low Freq scroll box and the High Freq scroll box appear in the panel display.
13.
Using the up and down arrow buttons, select the low frequency you desire.
14.
Using the left and right arrow buttons, select the high frequency scroll box .
15.
Using the up and down arrow buttons, select the high frequency you desire.
To configure a bandpass range for Outputs , do the following:
1.
Starting at the Audio Options|Advanced|Filters menu, select Bandpass .
Inputs and Outputs appears in the panel display.
2.
Using the arrow buttons, select Output .
3.
Press the SEL button .
Left Hdst, Matrix Out, OMNEO 1, OMNEO 2, Preamp Out, and Right Hdst appear in the panel display.
Or if the AUDIO package has been purchased, OMNEO 1-8 displays
4.
Using the arrow buttons, select the output you desire to modify.
If Left Hdst or Right Hdst is chosen:
a.
Press the SEL button .
Both, Left Chan, and Right Chan appear in the panel display .
b.
Using the left and right arrow buttons, select either Both , Left Chan , or Right Chan .
5.
Press the SEL button .
Frequencies and Mode appear in the panel display.
6.
Using the arrow buttons, select Mode .
Disabled and Enabled appear in the panel display .