RTS DKP-4016, Technical Manual

Page: 155 / 282

DKP-4016 Firmware Download 155
Bosch Security Systems, Inc. Technical Manual F.01U.308.248 Rev. 03
Enable Downloading New Bootloader from the Keypanel
By default, the keypanel does not allow downloading different bootloader version – this can be enable in the keypanel menu.
To enable the bootloader firmware downloads on the keypanel , do the following:
1.
While pressing the Main Vol and Aux Vol encoders on the front of the keypanel at the same time, press the MENU
button .
The main menu appears in the panel display.
2.
Using the left and right arrow buttons, select Service .
3.
Press the SEL button .
The Service menu options appear in the panel display .
4.
Using the left and right arrow buttons, select Boot Code .
5.
Press the SEL button .
Allow Download and Version X.X.X (where X represents version numbers) appears in the panel display.
6.
Using the left and right arrow buttons, select Allow Download .
7.
Press the SEL button .
The keypanel now allows download of new bootloader firmware.
NOTE: If the keypanel is powered off or loses power, the state of the Allow Download option resets to not enabled.
You must reconfigure the option for it to allow new bootloader firmware to be downloaded.
Download Firmware Using the Bootloader
The Bootloader is used to upload a new bootloader image or to upgrade the keypanel firmware if it is corrupt or fails and
makes downloading of new firmware impossible.
If the keypanel firmware is corrupt, the panel may boot automatically into the bootloader. However, if the keypanel firmware
appears valid, but fails to run properly, you may need to force the keypanel into the bootloader in order to download the new
firmware.
NOTE: The instructions provided below are shown using the KP-5032 family keypanels.
Run the Bootloader
To run the bootloader , do the following:
1.
Power off the keypanel.
2.
Verify the DKP-4016/4016W is powered off , but still connected to the FRAME.