RTS DKP-4016, Technical Manual

Page: 22 / 282

22 Installation DKP-4016
Bosch Security Systems, Inc. Technical Manual F.01U.308.248 Rev. 03
Configure the OMI using IPedit
To configure the OMI using IPedit , do the following:
Using the Device Configuration and Status Pane
1.
In the Device Name field, enter a device name familiar to you.
Initially, OMI cards are given a default name.
IMPORTANT: If you change the device name, this causes the device to reboot. It is not necessary to change the device
name. However, if you do change the name, it is best to do this early in the setup so you do not have to
revisit other devices that connect to this device and update them later.
2.
In the Description field, enter a description for the OMI card , if desired.
Using the Channel Configuration and Status Section:
3.
In the Channel Description field, enter a channel description , if applicable.
4.
From the Destination Type drop down menu, select OKP .
NOTE: The Destination Type does not need to be selected if using the Browse window to select the device. It fills
the type and IP Address automatically. The type is either OKP-2 or OKP-8 depending on the license for 2 or
8 OMNEO channels.
5.
In the Destination Device Name field, enter the name of the device to which the channel will connect.
OR
Click the
... button.
The Discovered Devices Window appears .
Expand the tree to view the destination devices available.
From the expanded tree, select the device you want for your destination device.
Click OK .
6.
From the Destination Channel drop down menu, select the channel to which the OMI will connect.
7.
Send the changes to the OMI.