RS PRO RSDM-9060, User Manual

Page: 364 / 412

364
rspro.com
RS-232C Interface Commands
SYSTem:LOCal
Enables local control (front panel control) and disables remote
control.
SYSTem:REMote
Enables remote control and disables local control (front panel
control, all key are disable except Shift key(return to local
control)).
SYSTem:RWLock
Enables remote control and disables local control (front panel
control, all key are disable).
STATus Report Commands
STATus:OPERation:CONDition?
Returns the total number of the Operation Condition register.
Return parameter: <NR1>, Ex: +4096
● A condition register continuously monitors the state of the
instrument. Condition register bits are updated in real time;
they are neither latched nor buffered.
This register is read-only; bits are not cleared when read.
STATus:OPERation:ENABle
Sets bits in the Operation Enable register.
Parameter: <NR1> (0~32767)
Example: STAT:OPER:ENAB 10
Sets the bit1 and bit3 in Operation Enable register, 10 = 2
1
+ 2
3
.
●
The selected bits are then reported to the Status Byte. An
enable register defines which bits in the event register will be
reported to the Status Byte register group. You can write to or
read from an enable register.
● A STATus:PRESet clears all bits in the enable register.
● The *PSC command controls whether the enable register is
cleared at power on.
STATus:OPERation:ENABle?
Returns the total number of the Operation Enable register.
Return parameter: <NR1>, Ex: +256