RS PRO RSDM-9060, User Manual

Page: 250 / 412

250
rspro.com
6. Press the F5 (Enter) key or Knob
key again to confirm the USB
Protocol option.
7. Connect the USB cable to the rear
panel terminal (upper port).
Set the USB Protocol
Description
The USB device port on the rear panel is used for
remote control. The USB port can be configured as
either a TMC or CDC interface.
Before the RSDM-9060/9061 can be used for
remote control utilizing the CDC or TMC USB
class, install the appropriate CDC or TMC USB
driver included on the User Manual CD.
USBCDC:
The USB port on the RSDM-9060/9061 will appear
as a virtual COM port to a connected PC.
USBTMC:
The RSDM-9060/9061 can be controlled using
National Instruments NI-Visa software*. NI-Visa
supports USB TMC.
Note
*To use the TMC interface National Instruments
Measurement and Automation Explorer can be
used. This program is available on the NI website,
www.ni.com ., via a search for the VISA Run-time
Engine page, or “downloads” at the following
URL, http://www.ni.com/visa/