Ross Synergy 100, Installation Manual, Page: 80 / 246

4–6 • Preliminary Video Installation Synergy 100 Installation Guide (v16.10-S100)
Notes on Installing Control Panel Pushbutton Inserts
Please note the following:
• When reinstalling the lens assembly, line up the alignment and locking tab on the key
cap with the alignment tab of the lens cap, and then with the locating slots in the primary
input switch in the panel. Otherwise, the lens cap may pop off when the switch is pressed
and released.
• The designation film must read correctly with the lens alignment tabs at the top and
bottom,
not at the sides.
• Perform this procedure for all buttons on each bus on your switcher.
Aux Bus Panel Pushbutton Inserts
Use the following procedure to install all Aux Bus pushbutton inserts. Use the diagram below for
reference.
Remote Aux Panel Pushbutton Inserts
1. Cut out designation film inserts for Aux Bus pushbuttons in all remote Aux panels. Note
that the inserts used will be the same as those used for the switcher primary inputs, with
the exception that Aux panels do
not have Color Background labels.
2. Remove the lens cap by placing a fingernail under the side of the cap and gently pulling
upward.
3. Position the insert in the lens cap.
4. Replace the paper background, then replace the lens cap on the switch and button
assembly.
5. Press down firmly to re-seat the cap.
This completes the procedure to install all Aux Bus pushbutton inserts.
Operating
Tip
For best results when cutting out the button inserts, use a sharp
X-ACTO
®
knife and a steel-edged ruler.
Transparent Lens Cap
Designation Insert
(may be colored)
White Paper Background
Switch and Button Assembly