Ross Synergy 100, Installation Manual, Page: 142 / 246

8–8 • Additional Installation Setups Synergy 100 Installation Guide (v16.10-S100)
2. Press
3. Ancillary data
to display the Ancillary Data Menu .
Ancillary Data Menu
3. Select the desired field (line) as follows:
• Press
0. Field (line)
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select the desired
field (line).
• Press the right
SEL
button to accept the new settings.
4. Set the mode for the selected line as follows:
• Press
1. Mode
.
• Toggle the
SEL
button to choose between
Pass
and
Strip
.The graphical display
will show either a
P
or an
S
, depending on your selection.
• Press the right SEL button to accept the new settings.
5. Select an image start point as follows:
• Press 2. Image starts at .
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select the image
start point. As the line number increases, the legend area displays additional S’s
with line numbers to reflect this change. You can then pass or strip these lines as
required.
Note The highlighted value on the graphical display moves to indicate the
selected line.
Note The Switching line (line 10 in 525 systems and line 6 in 625 systems)
is always stripped and cannot be changed.
If your Synergy 100 switcher is a 625 system (operating in PAL),
included on the menu is a legend identifying the abbreviations used in
the graphical display.
Ancillary data
0. Field (line)
1. Mode odd ( 1)
Pass
2. Image starts at
odd ( 20)
even (264)
Strip
even (283)
SSSSS SSSSF SSSSS SSSS S
5 10 15 20 HB
268 273 278 283
MENU
Exit 100
Previous SEL
Accept 10
Down 1
Up