Ross Synergy 100, Installation Manual, Page: 62 / 246

2–28 • Installation Synergy 100 Installation Guide (v16.10-S100)
Options Menu
An Options menu is available that allows you to verify all of the installed options in your Synergy
100 switcher.
The following topics are discussed in this section:
• Menu Access
• Options Menu
• Installing Software Options
Menu Access
All menus are accessed in the Preview Overlay mode. Refer to the section “ Menu System Basics ”
on page 5-2 for complete instructions.
• Press
MENU
to display the Main Menu .
Synergy 100 Main Menu
Options Menu
The Options Menu lists the hardware options that have been installed in your system and allows you
to link to the Software Options Menu . Verify that all options ordered are installed. If not, contact
Ross Video Technical Support .
Use the following procedure to verify that all options ordered are installed:
1. Navigate to the Options Menu as follows:
• Press MENU (to display the Main Menu ).
• Press 7. Options in the Effects Control group (to display the Options Menu ).
Important
Serial numbers allow Ross Video to properly track which options have
been purchased by each customer. Serial numbers are installed in flash
memory at the factory.
Main Menu - Synergy 100
0. Effects
1. Inputs
2. Outputs
3. GPIs
4. Communication
vX.XX-S100
5. Disk
6. Personality
7. Options
8. S&T 3D
9. Default
MENU
Exit 100
Previous SEL
Accept 10
Down 1
Up