Ross Synergy 100, Installation Manual, Page: 175 / 246

Synergy 100 Installation Guide (v16.10-S100) Completing Setup • 9–5
Upgrading Software Using a USB Key
Please note:
• Synergy 100 systems released before version 16 are able to load version 16 or later
software, and revert back to earlier versions.
• If you have received a Synergy 100 system with version 16 software already loaded on
it, you will
not be able to load pre-version 16 software onto it regardless of whether you
have a USB port or floppy disk drive.
• The following messages may be displayed on the Synergy 100 control panel during the
software upgrade process:
~
WAIT USB
— This message informs you that the Synergy 100 control panel is
trying to communicate with the USB port and read the USB key. Once the control
panel detects the USB key, the message is no longer displayed.
~
USB UPGD
— This message informs you that the Synergy 100 switcher is in the
process of a software upgrade and will be displayed until the process is complete.
~
USB UPGD FAIL
— This message informs you that the Synergy 100 control panel
has failed to upgrade. Contact Ross Video Technical Support for more information.