Ross Synergy 100, Installation Manual, Page: 221 / 246

Synergy 100 Installation Guide (v16.10-S100) Appendix C. Diagnostics • 12–5
Communication Port Monitoring
Use the Communication Port Monitoring Setup procedure to set up monitoring capabilities for the
data transmitted and received through your communication ports. This function is provided as a
troubleshooting tool to assist Ross Video Technical Support.
Use the following procedure to configure the Communication Port Monitoring:
1. Navigate to the Communication Menu as follows:
• Press MENU to display the Main Menu on the Preview Overlay .
• Press 4. Communication to display the Communication Menu .
Communication Menu
2. Press 7. Monitor to display the Monitor Menu .
Communication – Monitor Menu
3. Select a port to monitor as follows:
• Press 0. Port .
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select the
communication port you want to monitor. You can choose between the following:
~
Panel
~ Editor
Note
Regardless of the communications parameters you are configuring, for
example editor, audio mixer, or tally system interface equipment,
7
will always be Monitor .
Communication
0. Port
1. Type Editor
Editor
MENU
Exit
100
Previous
10
Down
1
Up
SEL
Accept
2. Device
3. Baud
4. Parity GVG4000
38400
Odd
5. Protocol
6. Input
RS232
None
7. Monitor
8. Option
9. Reserved
None
Monitor
0. Port
1. Format Panel
Hex
MENU
Exit
100
Previous 10
Down
1
Up
SEL
Accept
2. Tx/Rx
3. Freeze
4. Clear Rx
No
5. Address 000