Ross Synergy 100, Installation Manual, Page: 139 / 246

Synergy 100 Installation Guide (v16.10-S100) Additional Installation Setups • 8–5
3. Press
MENU
to display the Installation Change Screen .
4. Accept or cancel these changes as follows:
• Press
0. Confirm
to accept the changes.
• Press
1. Cancel
to exit the menus safely, without making any changes. The system
returns to the previously stored settings.
This completes the procedure to set the output aspect ratio.
Reference Delay
Each Synergy frame auto-times any source that is within
±
¼ line of the reference input. Typically, no
special procedures are required in order to time your inputs. However, if you wish to adjust the
switcher’s reference delay in order to match the
PGM and PST buses to incoming sources, select the
Ref Dly in the Outputs Menu .
Use the following procedure to adjust the reference delay of the Synergy 100 switcher:
1. Navigate to the Outputs Menu as follows:
• Press MENU to display the Main Menu on the Preview Overlay .
• Press 2. Outputs to display the Outputs Menu .
Outputs Menu
2. Adjust the reference delay of the switcher as follows:
• Press 1. Ref Dly .
• Use the Aspect knob on the control panel to set the reference delay. The full
adjustable range is 0 through 7FF hex, which represents 64 microseconds or a full
line of video.
As the
Aspect knob is adjusted, the secret-til-lit bus indicators on the control panel
will change color as the buses drift in and out of sync.
~ Orange indicates non-synchronous sources.
~ Green LEDs signify synchronous sources.
• Press SEL when both buses indicate that they are in sync.
Note
The Synergy frame provides no adjustment for key timing. All key
timing adjustments must be made
at the source .
Note When the Ref Dly is selected, the value in the sub heading changes
color and becomes active .
Outputs
0. Aspect
1. Ref Dly 4:3
300
MENU
Exit 100
Previous SEL
Accept 10
Down
1
Up
2. Clean BeforeKeys
3. Ancillary data
4. RemAuxPrg Off
5. Fld Dom Field1