Ross Synergy 100, Installation Manual, Page: 46 / 246

2–12 • Installation Synergy 100 Installation Guide (v16.10-S100)
Hardware Installation
This section describes procedures for installing the following main components of the Synergy 100
switcher system:
• Control panel
• Optional Sliding Shelf
• Remote Aux panels
• Electronics frame
This equipment is intended to be installed and serviced by qualified personnel only. All cautionary
rules regarding static discharge apply. Refer to the section “
Static Discharge ” on page 2-2 for details.
Installing the Control Panel
The control panel is shipped with all its circuit boards in place — you only have to install the control
panel tub and some push-button inserts. The tub is available in two models — one which is designed
to be set into a desk (or console cutout) and the other which simply can be set on the desktop.
Use the following procedure to install the control panel into a desk or console cutout:
1. For in-console installation, measure your console according to the measurements
illustrated in the following diagram. Centimeters are shown in parenthesis.
Synergy 100 Control Panel Cutout Dimensions
Caution
Switch the power off before installing or removing printed circuit
boards. Note that the frame and control panel have separate power
supplies. The circuitry used throughout the switcher is largely CMOS,
accounting for the system’s low current drain.
Note The control panel is designed as a closed unit and as such there is no
need to access the inside of the panel under normal conditions.
Cutout - Synergy 100
16.00" (40.64 cm)
13.25"
(33.66 cm)
Cable Clearance
4.0" (10.16 cm)
4.0" (10.16 cm)
Distance from Cutout
to Console Front
(Recommended)
Console Front
Console Top