Ross Synergy 100, Installation Manual, Page: 106 / 246

7–6 • Communication Setup Synergy 100 Installation Guide (v16.10-S100)
Editor Communication Setup
The Communication Menu allows the user to setup an external edit controller to control your
Synergy 1 frame and Synergy 100 panel.
The communication port for the edit controller is located on the rear of the Synergy 1 frame as shown
below.
Editor Communication Port
• The port requires a 9-pin “D” serial cable.
• Refer to the edit controller’s Installation Manual for details on its specific remote
control communication port.
Editor Setup
The Editor Communication Setup procedure allows you to set up communication with an external
edit controller. Once completed, the editor can control the Synergy 1 frame and Synergy 100 panel
with a variety of standard and advanced edit control functions.
Use the following procedure to set up communication with an external editor:
1. Navigate to the Communication Menu as follows:
• Press MENU to display the Main Menu on the Preview Overlay .
• Press 4. Communication to display the Communication Menu .
Communication Menu — Editor
Note
Refer to section “ Options Menu ” on page 2–28 to ensure that the
Editor option is installed. If not, please contact Ross Video Technical
Support for details.
TALLY
9 11 13 15
10 12 14 16 COMMON
1 3 5 7
2 4 6 8 COMMON
EDITOR DVE
2
1
Communication
0. Port
1. Type Editor
Editor
MENU
Exit
100
Previous
10
Down
1
Up
SEL
Accept
2. Device
3. Baud
4. Parity GVG4000
38400
Odd
5. Protocol
6. Input
RS232
None
7. Monitor
8. Option
9. Use Break
Use Break
Yes