Ross Synergy 100, Installation Manual, Page: 222 / 246

12–6 • Appendix C. Diagnostics Synergy 100 Installation Guide (v16.10-S100)
~ DVE
~ Periph1
~ Periph2
• Press the right
SEL
button to accept the new settings.
4. Select a format to display the monitoring information as follows:
• Press
1. Format
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select a format to
display the monitoring information from the selected communications port. You can
choose between the following:
~
Hex
— Use this option to display the raw data in Hexadecimal format.
~
ASCII
— Use this option to display the raw data in American Standard Code
for Information Interchange format.
• Press the right
SEL
button to accept the new settings.
5. Select the type of monitoring as follows:
• Press
2. Tx/Rx
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select the traffic
flow to monitor on the selected communications port. You can choose between the
following:
~
Tx
— Use this option to monitor the Transmit data from the selected port.
~
Rx
— Use this option to monitor the Receive data from the selected port.
• Press the right
SEL
button to accept the new settings.
6. Send or receive data as follows:
• Press
3. Freeze
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select whether to
receive data or not. You can choose between the following:
~
Yes
— Use this option to stop receiving data.
~
No
— Use this option to begin sending or receiving data.
• Press the right
SEL
button to accept the new settings.
7. Select to delete all current data from the buffer as follows:
• Press
4. Clear
.
• Press the right SEL button to accept the new settings.
8. Select a buffer location that is beyond the visible display parameters as follows:
• Press
5. Address
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select the buffer
location.
• Press the right SEL button to accept the new settings.
9. Press
MENU
to display the Installation Change Screen .