Ross Synergy 100, Installation Manual, Page: 45 / 246

Synergy 100 Installation Guide (v16.10-S100) Installation • 2–11
• Perform the basic cabling:
~ control panel to frame interconnection
~ remote Aux panel cabling
~ reference input
~ switcher interconnections
~ connections to preview and program monitors
• Power up and do a quick video check on the switcher.
• Decide on inputs to the switcher’s primary input sections and install push-button inserts
accordingly.
• Connect primary inputs.
• Connect output monitors as required for your installation.
• Make connections to external equipment. The ways of connecting such sources will
depend on personal preference as well as on the combination of options purchased with
the switcher.
• Connect character generator key (alpha) and video input signals.
• Connect the tallies.
• Connect and set up the general purpose interface inputs.
• Configure the switcher personality according to your installation requirements and
personal preferences. The many operational parameters include editor related functions,
auto keying selections, Aux Bus and memory configuration and various button
assignments and operational shortcuts.
Important The cable for connecting the Synergy 100 Control Panel to the
Synergy 1 Frame is not wired as a standard CAT5 ethernet cable. If
you need a cable of a specific length, contact your Ross Video
Representative for ordering information.
Note The previous steps cover switcher installation and configuration.
Additional appendices at the end of this guide provide supplementary
information for interfacing with DVEs and installing hardware
options.