Ross Synergy 100, Installation Manual, Page: 118 / 246

7–18 • Communication Setup Synergy 100 Installation Guide (v16.10-S100)
In order to allow the Synergy 100 Switcher to communicate with the audio mixer, you must configure
it as described in this section.
Use the following procedure to setup your Yamaha 01V96 Audio Mixer:
1. Press the
DIO/SETUP
function button in the Display Access Group to display the
DIO/SETUP Menu .
2. Press the
MIDI/HOST
tab to display the MIDI I/O HOST SETUP Menu .
3. Use the
Cursor
buttons to navigate to the following (you will have to press
ENTER
after each selection):
• Tx PORT — Use the Parameter Dial to set this to
MIDI
.
• Rx PORT — Use the Parameter Dial to set this to
MIDI
.
4. Press the
SETUP
tab to display the MIDI SETUP Menu .
5. Use the
Cursor
buttons to navigate to the following (you will have to press
ENTER
after each selection):
• Tx CH — Use the Parameter Dial to set this to
1
.
• Rx CH — Use the Parameter Dial to set this to
1
.
• Use the following table to set the indicated parameters:
• Fader Resolution — Use the Parameter Dial to set this to LOW .
This completes the procedure for setting up the Remote Audio Mixer to communicate with the
Synergy 100 Switcher.
Note For information on the Function Buttons and navigating the menu
system on your Remote Audio Mixer, refer to the documentation that
came with your Audio Mixer.
Yamaha 01V96 Setup
Tx Rx OMNI ECHO
Program Change ON ON OFF OFF
Control Change ON ON OFF --
Param Change ON ON -- OFF
Bulk -- OFF -- --
Other Commands -- -- -- OFF