Ross Synergy 100, Installation Manual, Page: 178 / 246

9–8 • Completing Setup Synergy 100 Installation Guide (v16.10-S100)
6. If you wish to store only individual 3D wipes , press
5. Store Indiv 3D Wipe
to display
the Store Indiv 3D Wipe Menu .
Store Indiv 3D Wipe Menu
• Use the HUE knob in the Mattes Group to select the 3D wipe effect from the
switcher that you want to save.
Note that the wipe location at the To Disk heading changes in accordance with the
selection at the From Switcher heading.
• Use the SAT knob in the Mattes Group if you wish to store the 3D wipe effect to a
different location on the floppy disk or USB key than currently selected. Rotate the
knob to scroll to the desired location.
• Press SEL in the System Control Group to accept. The wipe effect is written to the
file STSEQXX.SEQ , where XX is the wipe number from 00 to 99 .
7. During the storing process, and depending on the registers being stored, the following
menu (or a variation thereof) is displayed on your preview monitor:
Message Received During Storing Process
This menu follows the progress of your storing procedure, and gives you the
opportunity to cancel the operation, if desired.
8. When the transfer is complete, eject the storage device from the switcher.
Caution Do NOT remove the floppy disk or USB key from the switcher before
the LED on the floppy drive or USB port goes out. Doing so may
destroy the data on your floppy disk or USB key, as well as the data on
the next one you insert into the switcher.
Store Indiv 3D Wipe
From Switcher : PageRoll
ShockWve
To Disk : Seq 00
Seq 01
Use HUE or SAT to scroll list and the System
Control SEL to accept.
Store All
________
Memory Transfer: 1% Complete
100
Cancel