6.
Set the drying method and time after printing.
Procedure
1.
Press [
▲
] or [
▼
] to select "ENABLE" or "DISABLE".
Set whether the media should be fed until the trailing edge of the printed area is put on the dryer after
the 1st page is printed. To make sure to dry the entire printed area, select "ENABLE". If "DISABLE" is select-
ed, the trailing edge of the printing area is not fed to the dryer unless you continue with a subsequent
printing operation.
FEED FOR DRY
DISABLE ENABLE
2.
Press [ENTER] to confirm your entry.
3.
Press [
▲
] or [
▼
] to set the drying time.
Set the drying time after the 1st page is printed. The next operation is not started until the set time pass-
es.
DRYING TIME
10min 10min
MEMO
• When the drying time has been set in the software RIP, priority is given to the software RIP's setting.
• Example of setting time (general guide)
The setting time varies according to the settings such as the type of media and the printing quality.
• Condition Non-coated vinyl chloride media
• Setting time: About three minutes
4.
Press [ENTER] to confirm your entry.
Printing Output
62
1. Printing Method
Summary of Contents for TrueVIS VF2-640
