Command Reference
R&S
®
CMW-KM750/-KM751
65
User Manual 1173.9670.02 ─ 05
Parameters:
<Band>
B1 | B2 | B3
B1:
Band 1 (F), 1880 MHz to 1920 MHz
B2:
Band 2 (A), 2010 MHz to 2025 MHz
B3:
Band 3 (E), 2300 MHz to 2400 MHz
*RST:
B2
Example:
See
Specifying General Measurement Settings
Firmware/Software:
V1.0.4.11
V3.0.10: modifying the band does no longer modify the channel/
frequency
Manual operation:
See
CONFigure:TDSCdma:MEAS<i>:RFSettings:FREQuency
<Frequency>
Selects the center frequency of the RF analyzer.
Parameters:
<Frequency>
Range:
100E+6 Hz to 6E+9 Hz
*RST:
2.0108E+9 Hz
Default unit: Hz
Using the unit CH the frequency can be set via the channel num-
ber. The allowed range depends on the frequency band:
Band 1 (F): 9400 to 9600
Band 2 (A): 10050 to 10125
Band 3 (E): 11500 to 12000
Example:
See
Specifying General Measurement Settings
Firmware/Software:
V1.0.2.7
V3.0.10: modifying the frequency does no longer modify the band;
unit CH allows to set the frequency via the channel number
Manual operation:
See
CONFigure:TDSCdma:MEAS<i>:RFSettings:ENPower
<ExpNomPow>
Sets the expected nominal power of the measured RF signal.
Parameters:
<ExpNomPow>
The range of the expected nominal power can be calculated as
follows:
Range (Expected Nominal Power) = Range (Input Power) + Exter-
nal Attenuation - User Margin
Range:
–47 dBm to 35 dBm for the input power at the RF
COM connectors (please notice also the ranges quo-
ted in the data sheet).
*RST:
0 dBm
Default unit: dBm
Example:
See
Specifying General Measurement Settings
General Measurement Settings
