RJG Lynx LS-B-127-125, Product Manual

Page: 24 / 66

Lynx™ Strain Gage Button Sensors LS‑B‑127‑50/125/500/2000 | Product Manual 16 RJG, Inc.
INSTALLATION SPECIFICATIONS ( continued )
1.
Sensor Head Pocket
Sensor head pockets are machined into the
clamp plate. The sensor pockets must be
centered under the selected ejector pin
measuring 0.510” +0.005/‑0.0 (13,0 mm
±0,10 [
1
at right ]) DIA, and 0.374” +0.002/
‑0.001 (9,49 mm ±‑0,04 [
2
at right ]) deep,
with an added clearance of 0.01” (0,3 mm [
3
at right ]) MIN above the sensor head.
2.
Transfer Pin Shaft Pocket
Choose an ejector and transfer pin appropriate
for the application (refer to “Sensor and Ejector
Pin Size” on page 2). Ejector and transfer
pin must be concentric within 0.030” (0,76 mm)
or 10% of ejector pin diameter—whichever is
smaller. Ejector and transfer pin must be equal
in diameter.
Transfer pin pockets must be centered under
the selected ejector pin.
Machine a pocket for the transfer pin shaft from
the sensor head pocket through the clamp
plate equaling the transfer pin DIA
plus 0.04”
(1,0 mm) if pin DIA is < 0.12” (3,0 mm) DIA,
or 0.06” (1,5 mm) if pin DIA is > 0.12” (3,0
mm[
4
at right ]).
Chamfer the transfer pin head pocket at 30°
(
5
at right) for a depth equal to the pin
diameter at exit of clamp plate.
1
4
5
2
3
1
0.510” +0.005/‑0.0 (13,0 mm ± 0,10) DIA
2
0.374” +0.002/‑0.001 (9,49 mm ± 0,04)
3
0.01” (0,3 mm) MIN
4
transfer pin DIA + 0.04” (1,0 mm) if < 0.12” (3,0 mm), OR + 0.06” (1,5 mm) if > 0.12” (3,0 mm)
5
30° Chamfer, Depth = Pin DIA
CLAMP PLATE (HEAD‑TO‑HEAD) INSTALLATION