RJG Lynx LS-B-127-125, Product Manual

Page: 25 / 66

Product Manual | Lynx™ Strain Gage Button Sensors LS‑B‑127‑50/125/500/2000 RJG, Inc. 17
3.
Transfer Pin Shaft and Head Pocket
Machine a pocket for the transfer pin shaft in
the ejector plate with an H7/g6 fit for 0.5”
(12 mm [
1
at right ]) MIN.
Machine a pocket for the transfer pin head in
the ejector plate that is equal to the transfer pin
head DIA
plus
0.02” (0,5 mm [
2
at right
]) MIN
per side. Allow 0.01” (0,3 mm [
3
at right
])
MIN clearance below pin head. Chamfer the
transfer pin head pocket at 45° (
4
at right)
.
4.
Ejector Pin Head Pocket
Machine a pocket for the ejector pin head in the
ejector retainer plate that is equal to the ejector
pin head DIA
plus 0.02” (0,5 mm [
5
at right ])
MIN per side.
Allow clearance above the ejector pin head.
If the part thickness is < 0.05” (1,5 mm),
the clearance should equal 20% of the part
thickness. If the part thickness is > 0.05”
(1,5 mm), the clearance should equal 0.01”
(0,3 mm [
6 i
at right ]).
NOTE Ejector pin head clearance not to
exceed 20% (1/5th) of part thickness at point of
pin/part convergence.
Chamfer the lead‑in edge 45° (
7
at right
).
CAUTION
Transfer pin applications require
guided ejection; failure to comply may result in
damage to or destruction of components.
1
H7/g6 for 0.5” (12 mm) MIN
2
0.02” (0,5 mm) MIN per side
3
0.01” (0,3 mm) MIN
4
45° Chamfer, refer to ”Chamfer Length” on page 15
5
0.02” (0,5 mm) MIN per side
6 20% part thickness if < 0.05” (1,5 mm), 0.01” (0,3 mm) if part thickness > 0.05” (1,5 mm) i
7
45° Chamfer, refer to ”Chamfer Length” on page 15
INSTALLATION SPECIFICATIONS ( continued )
2
1
3
4
5
6
7
CLAMP PLATE (HEAD‑TO‑HEAD) INSTALLATION