RJG Lynx LS-B-127-125, Product Manual

Page: 27 / 66

Product Manual | Lynx™ Strain Gage Button Sensors LS‑B‑127‑50/125/500/2000 RJG, Inc. 19
INSTALLATION SPECIFICATIONS ( continued )
The minimum cover plate thickness (
1
at
right ), regardless of sensor retaining plate
method, corresponds to the sensor force range
model, as shown in the table below.
COVER PLATE THICKNESS MIN
Sensor Model Plate Thickness MIN Fastener
LS‑B‑127‑50 0.2” (5,0 mm)
8‑36 LSHC
(M4 CZHC)
LS‑B‑127‑125 0.2” (5,0 mm)
8‑36 LSHC
(M4 LSHC)
LS‑B‑127‑500 0.25” (6,0 mm)
10‑32 LSHC
(M5 LSHC)
LS‑B‑127‑2000 0.25” (6,0 mm)
10‑32 LSHC
(M5 LSHC)
Incorporate and install screws (
2
at right
)
in the cover plate design on each side of the
sensor diameter to avoid any bending of the
cover; incorporate and install other screws as
necessary to secure cover. RJG recommends
the use of 8‑36 or 10‑32 LSHC (M4 or M5
CZHC).
Clamp plate cover design is determined by
customer. Contact RJG customer support
(see page 54 for contact information) for
questions.
1
Cover Plate Thickness, MIN (refer to table)
2
Cover Plate Screws 8‑36 or 10‑32 LSHC (M4 or
M5 CZHC)
1
2 2
COVER PLATE—CLAMP PLATE INSTALLATIONS