RJG Lynx LS-B-127-125, Product Manual

Page: 46 / 66

Lynx™ Strain Gage Button Sensors LS‑B‑127‑50/125/500/2000 | Product Manual 38 RJG, Inc.
3.
Indentation Test (with Ejector Pin)
With the ejector pin installed, push on the ejector pin; verify the clearance of 0.012” (0,3 mm (or
1/5 part thickness)) exists between the bottom of the ejector pin head and the ejector retainer plate
surface
.
4.
Flush Test (Full Stack)
With the sensor, ejector, and transfer pin installed, and the ejector plate in the injection position,
fixed towards clamp plate, the ejector pin should be flush with the ejector plate/cavity surface.
SENSOR INSTALLATION CHECK—CLAMP PLATE (TYPICAL) INSTALLATION ( continued )
Ejector Retainer Plate
Ejector
Retainer
Plate Clamp
Plate Cover
Plate Ejector
Plate
B Plate or Cavity Insert
B Plate
or
Cavity
Insert
Ejector Pin
Ejector Pin Transfer Pin Sensor