Riverbed Cascade Express, Installation Manual

Page: 81 / 92

Cascade Installation Guide
71
8. Check to ensure that the new RMM address information is displayed in the
RMM Settings section.
9. At the bottom of the Setup page, there is a checkbox labeled Power down
after configuration .
•
If the Gateway is mounted in the rack and you are ready to connect it
to the network, leave the
Power down after configuration box
unselected and click Configure Now .
•
If the Gateway must be powered off and mounted in the rack before it
can be connected to the network, select the
Power down after
configuration box and click Configure Now .
10. When you click Configure Now , you will be prompted to change the
password. The password you enter here must be the one you use after this
point in the procedure. Enter your new password.
11. When the password change operation is completed, exit from the browser
session and disconnect the crossover cable from the Gateway.
Additional configuration, such as specifying Profilers that are to receive data from
the Gateway and forwarding flow data from particular sources to particular
Profiler destinations, can be performed by logging in to the Gateway GUI after it
is connected to the management network.
If the Gateway is mounted in the rack and ready to connect to the network,
proceed to the next section,
Network connections .
If the Gateway still needs to be mounted, wait for it to power down and then
mount it in the rack as described in Section 3,
Mounting and powering section
before proceeding to the next section, Network connections .
Network connections
After the Gateway is mounted, configured, and has been powered on for more
than two minutes, connect the network cable and verify the connection as follows:
1. Connect the cable from your management network to the Management
connector on the rear of the Gateway. This is the same connector that you
used to configure the Gateway.