Riverbed Cascade Express, Installation Manual

Page: 56 / 92

Cascade Installation Guide
46
5. In the RMM Settings section, click Set up RMM . This opens a setup
page.
6. Enter the factory preset username
admin
and password
password
in the
setup popup.
7. Enter the RMM network interface IP address, netmask and gateway and
click
OK .
8. Check to ensure that the new RMM address information is displayed in the
RMM Settings section.
9. At the bottom of the Setup page, there is a checkbox labeled Power down
after configuration .
•
If the Sensor is mounted in the rack and you are ready to connect it to
the network, leave the
Power down after configuration box
unselected and click Configure Now .
•
If the Sensor must be powered off and mounted in the rack before it
can be connected to the network, select the
Power down after
configuration box and click Configure Now .
10. When you click Configure Now , you will be prompted to change the
password. The password you enter here must be the one you use after this
point in the procedure. Enter your new password.
11. When the password change operation is completed, exit from the browser
session and disconnect the crossover cable from the Sensor.
Additional configuration tasks, such as specifying the Profilers to which the
Sensor is to send data, can be performed by logging in to the Sensor GUI after it
is connected to the management network.
If the Sensor is mounted in the rack and ready to connect to the network, proceed
to the next section,
Network connections .
If the Sensor still needs to be mounted, wait for it to power down and then mount
it in the rack as described in Section 3,
Mounting and powering , before
proceeding to the next section, Network connections .