Riverbed Cascade Express, Installation Manual

Page: 33 / 92

Cascade Installation Guide
23
4. In the RMM Settings section, click Set up RMM . This opens a setup
page.
5. Enter the factory preset username
admin
and password
password
in the
setup popup.
6. Enter the RMM network interface IP address, netmask and gateway and
click
OK .
7. Check to ensure that the new RMM address information is displayed in the
RMM Settings section.
8. At the bottom of the Setup page, there is a checkbox labeled Power down
after configuration . This is provided for situations in which someone
configures the Enterprise Profiler in a staging area and then subsequently
moves it to another area.
•
If the Profiler is mounted in the rack and connected to the network on
which you will be using it, leave the
Power down after configuration
box unselected and click Configure Now .
•
If the Profiler must be powered off, remounted, and reconnected
before it is deployed, select the
Power down after configuration box
and click Configure Now .
9. When you click Configure Now , you will be prompted to change the
password. The password you enter here must be the one you will use after
this point in the procedure. Enter your new password.
Configuring Remote Management Modules
To configure the RMMs in the Database Module and Expansion Modules,
1. Disconnect the laptop you used to configure the Management Module
from the network.
2. Using a crossover cable, connect it to the RMM connector on the Database
Module.