Riverbed Cascade Express, Installation Manual

Page: 76 / 92

Cascade Installation Guide
66
Data Sources – Use NetFlow
Specify the port number on which the Gateway will receive the data.
Applies only if the Gateway is receiving NetFlow data (versions 1, 5,
7 or 9), IPFIX, or cFlow data. See Note 1 at the end of this table.
Data Sources – Use sFlow
Specify the port number on which the Gateway will receive the data.
Applies only if the Gateway is receiving sFlow data (versions 2, 4 or
5). See Note 1 at the end of this table.
Data Sources – Use Packeteer
Specify the port number on which the Gateway will receive the data.
Applies only if the Gateway is receiving Packeteer Flow Detail
Records (versions 1 or 2). See Note 1 at the end of this table.
SNMP information:
The Gateway is set by default to use SNMP Version 1 and the SNMP
community name
mazu
(all lowercase) to allow MIB browsing. If you
are configuring SNMP at this time, obtain the necessary V1 or V3
information.
First Profiler data input address.
The address of the Profiler to which the Gateway will send traffic
data. This is the IP address of the management interface of an Express
or Standard Profiler or the address of the first Expansion Module
(mBlade 1) for an Enterprise Profiler.
If data sent to this Profiler is to be limited to only data received from
certain flow sources, then specify those sources.
Profiler IP address:
Flow sources:
Second Profiler data input address.
If the Gateway will be sending traffic data to more than one Profiler,
this is the IP address of the second Profiler (management interface of
an Express or Standard Profiler or the address of the first Expansion
Module for an Enterprise Profiler).
If flow forwarding to this Profiler is to be limited to only data
received from certain flow sources, then specify those sources.
Profiler IP address:
Flow sources:
Third Profiler data input address Profiler IP address:
Flow sources: