Riverbed Cascade Express, Installation Manual

Page: 40 / 92

Cascade Installation Guide
30
Monitored network port settings – mon1
10/100/1000 Mb/s, half- or full-duplex, or auto-negotiate
As required by the tap or mirror port on the monitored network. Does
not apply to flow-monitoring-only models.
Packet Deduplication
Enable packet deduplication if your network configuration might
cause the Cascade appliance to see duplicated packets.
NTP server IP addresses:*
Applies only if Express is being synchronized to an external NTP
server. Enter one or more addresses as a comma-separated list.
Time Zone:
NetFlow port:
Applies only if Express is receiving NetFlow data (versions 1, 5, 7 or
9) or IPFIX data. See Note 1 below.
sFlow port:
Applies only if Express is receiving sFlow data (versions 2, 4 or 5).
See Note 1 below.
Packeteer port:
Applies only if Express is receiving Packeteer Flow Detail Records
(versions 1 or 2). See Note 1 below.
SNMP information:
Express is set by default to use SNMP Version 1 and the SNMP
community name
mazu
(all lowercase) to allow MIB browsing. If you
are configuring SNMP at this time, obtain the necessary V1 or V3
information.
Outgoing mail server name, port number, and “From”
address.
Applies only if you will be specifying a server that Express is to use
for sending reports or alert notifications.
Inside addresses:
IP addresses or address ranges of hosts that the Express is to track
individually.