Riverbed Cascade Express, Installation Manual

Page: 53 / 92

Cascade Installation Guide
43
Monitored network port settings – mon1
10/100/1000 Mb/s, half- or full-duplex, or auto-negotiate
As required by the tap or mirror port on the monitored network.
Does not apply to Sensors with 10 Gbps interfaces.
Monitored network port settings – mon2
10/100/1000 Mb/s, half- or full-duplex, or auto-negotiate
As required by the tap or mirror port on the monitored network.
Monitored network port settings – mon3
10/100/1000 Mb/s, half- or full-duplex, or auto-negotiate
As required by the tap or mirror port on the monitored network.
Packet Deduplication
Enable packet deduplication if your network configuration might
cause the Cascade appliance to see duplicated packets.
Time Zone:
Flow encryption certificate (default or new certificate):
For faster installation, use the default encryption certificate shipped
with the Sensor and then generate a new certificate later.
SNMP information:
Sensor is set by default to use SNMP Version 1 and the SNMP
community name
mazu
(all lowercase) to allow MIB browsing. If you
are configuring SNMP at this time, obtain the necessary V1 or V3
information.
First Profiler data input address:*
The address of the Profiler to which the Sensor will send traffic data.
This is the IP address of the management interface of an Express or
Standard Profiler or the address of the first Expansion Module for an
Enterprise Profiler.
Second Profiler data input address:
If the Sensor will be sending traffic data to more than one Profiler,
this is the IP address of the second Profiler (management interface of
an Express or Standard Profiler or the address of the first Expansion
Module for an Enterprise Profiler).
Third Profiler data input address:
Fourth Profiler data input address: