Rigol DSA1000A Series, Programming Manual

Page: 25 / 174

Chapter 2 Command Systems
RIGOL
Programming Guide for DSA1000A series 2-11
Meas Setup, Fail Stop, On/Off
12. :CALCulate:LLINe:FAIL:RATIo?
Syntax :CALCulate:LLINe:FAIL:RATIo?
Function The query returns the failure rate from the test results, such as
0.00.
13.
:CALCulate:MARKer:AOFF
Syntax :CALCulate:MARKer:AOFF
Function Turns off all markers and functions based upon markers.
Front Panel Marker, All Off
14.
:CALCulate:MARKer<n>:CPEak[:STATe]
Syntax :CALCulate:MARKer<n>:CPEak[:STATe] OFF|ON|0|1
:CALCulate:MARKer<n>:CPEak[:STATe]?
Function Turns on or off the Cont Peak Search.
The query returns “0” or “1”.
Explanations

<n> is 1, 2, 3 or 4.

The command turns on Marker 1 automatically if none is
enabled.
Default OFF|0
Front Panel Peak, Cont Peak, On/Off
15.
:CALCulate:MARKer<n>:DELTa[:SET]:CENTer
Syntax :CALCulate:MARKer<n>:DELTa[:SET]:CENTer
Function Sets the center frequency to the frequency difference between the
two markers in “Delta”, “Delta Pair” or “Span Pair” marker.
Explanations

<n> is 1, 2, 3 or 4.

Sending :CALCulate:MARKer<n>:MODE selects a marker type
from “Delta”, “Delta Pair” or “Span Pair”.

The command is invalid in Zero-span mode.
Front Panel Marker, Delta/Delta Pair/Span Pair
Marker –>, MkrΔ->CF
16.
:CALCulate:MARKer<n>:DELTa[:SET]:SPAN
Syntax :CALCulate:MARKer<n>:DELTa[:SET]:SPAN
Function Sets the analyzer span to the frequency difference between the two