Ricoh SCRIPT2, Setup Manual

Page: 306 / 406

Appendix
80
6
Note
❒
If the “Can not write NVRAM information” message appears, the changes
are not saved. Repeat the steps above.
❒
The Network Interface Board is reset automatically when the settings are
changed.
❒
When the Network Interface Board is reset, the active print job which has
already been sent to the printer will finish printing. However, jobs that
have not been sent yet will be canceled.
Commands List
This is a list of commands that can be used via remote maintenance.
Note
❒
Type “help” to see a list of commands that can be used.
msh> help
❒
Type “help command_name” to display information about the syntax of that
command.
msh> help command_name
TCP/IP address
Use the ifconfig command to configure TCP/IP for the printer (IP address, sub-
net mask, broadcast address, default gateway address).
❖ ❖ ❖ ❖
Reference
msh> ifconfig
❖
❖ ❖
❖
Configuration
msh> ifconfig le0 parameter address
The following is an example for configuring an IP address of 192.168.15.16.
msh> ifconfig le0 192.168.15.16
The following is an example for configuring a subnet mask of 255.255.255.0.
msh> ifconfig le0 netmask 255.255.255.0
Note
❒
This affects the configuration of the Network Interface Board of the IP ad-
dress that is used.
❒
To type an address using hexadecimal, prefix it by “0x”.
Parameter Meaning
(no parameter) IP address
netmask subnet mask
gateway default gateway address