Ricoh SCRIPT2, Setup Manual

Page: 283 / 406

NetWare 3.x - Advanced Settings
57
4
Setting Up as a Remote Printer
A
Log on to the file server as a Supervisor or a Supervisor equivalent.
B
Run the NIB Setup Tool.
Reference
⇒
P.50 “Running the NIB Setup Tool”
C
Click [ Property Sheet ] and click [ OK ] .
The [ Browse ] dialog box of the Network Interface Board appears.
D
Click [ IPX protocol ] .
E
Click the IPX address of the Network Interface Board which is to be config-
ured, and click
[ Next > ]
.
Note
❒
If you do not know which Network Interface Board you are configuring,
see a network configuration page to confirm the MAC address (Network
Address).
F
Confirm that the MAC address and IPX address are correct, and click [ Fin-
ish ] .
The [ NIB Setup Tool ] window appears.
G
Click
[ Configure ]
.
The property sheet appears.
H
Click the [ General ] tab, and type the name of the print server into the [ Device
Name ] box.
I
Click the [ NetWare ] tab, and make the following settings.
A
In the
[ Print Server Name ]
box, type the name of the print server.
B
In the [ File Server Name ] box, type the name of the file server in which a
print server is to be created.
Clicking
[ Browse ]
, you can select a file server among those listed in the
[ Browse ]
dialog box.
C
In the
[ Print Server Operation Mode ]
group, click
[ As Remote Printer ]
.
D
In the [ Remote Printer No. ] box, type the printer number.
Important
❒
Use the same printer number as that to be created in the printer server.
E
Click [ OK ] to close the property sheet.
F
After a confirmation dialog box appears, click [ OK ] .