Ricoh SCRIPT2, Setup Manual

Page: 390 / 406

UNIX Configuration
2
1
Confirming the IP address
Follow the procedure below to confirm that the IP address has been configured
correctly.
• Following procedure uses sample IP address: 192.168.15.16.
A
Enter the following:
# ping 192.168.15.16
If the address has been configured correctly, the following message appears.
192.168.15.16 is alive
If the address has been configured incorrectly, the following message ap-
pears.
no answer from 192.168.15.16
Note
❒
When you use NIS, the IP address and host name are written to /etc/hosts
on the master server. When you use DNS, the information is written to a
data file on the name server. After writing the host name and IP address to
the file, confirm the configuration by pinging the host name.
# ping host_name
❒
If the host name is registered with an IP address, the server can access the
printer using its host name instead of its IP address.
Executing the Installation Shell Script
After having configured the printer IP address, follow the procedure below to
execute the installation shell script and set up the workstation printing environ-
ment.
Preparation
Before executing the installation shell script, the IP address, the host name
and the printer name must be required.
Following procedures use sample IP address: 192.168.15.16, sample host
name: nphost and sample printer name: np.
Note
❒
Use ftp to get the installation shell script from the printer.
A
Log on to the workstation as root.
Note
❒
If you do not log on as root, the installation shell script will not run.