Ricoh SCRIPT2, Setup Manual

Page: 308 / 406

Appendix
82
6
❒
For example, if you assign 192.168.15.16 as the Access Control Address of the
Network Interface Board, the IP addresses that can print are as follows. XXX
means any number from 1 to 255 is acceptable.
❖ ❖ ❖ ❖
Configuration for multiple access controls
msh> access multi {on | off}
“on” means active and “off” means inactive.
msh> access {1 - 5} parameter address
Note
❒
Up to 5 access controls are available. Specify the number (1 - 5) when con-
figuring some access controls. If this is not configured, the first setting is
selected.
Network Boot
Use the set command to configure the boot method.
msh> set parameter {on | off}
“on” means active and “off” means inactive.
Note
❒
When you use RARP+TFTP, BOOTP or DHCP, the server also needs to be
configured.
❒
DHCP takes precedence over all other settings.
Access Control Mask IP addresses that can access the
printer
0. 0. 0. 0 XXX.XXX.XXX.XXX
255. 0. 0. 0 192.XXX.XXX.XXX
255.255. 0. 0 192.168.XXX.XXX
255.255.255. 0 192.168. 15.XXX
255.255.255.255 192.168. 15. 16
Parameter Meaning
ping ARP+PING
tftp RARP+TFTP
bootp BOOTP
dhcp DHCP