Ricoh M281 Series, Service Manual

Page: 905 / 1003

Bit Switches - 1
SM 71 D255/D256 FAX OPTION
D255/
D256
F
A
X
OP
TI
ON
5 On hook dial
0: Disabled 1: Enabled
0: On hook dial is disabled.
6-7 Not used Do not change these settings
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E (SP No. 1-101-015)
No Function Comments
0-1 Not used Do not change the settings.
2 Enable/disable for direct
sending selection
0: Direct sending off
1: Direct sending on
Direct sending cannot operate when the
capture function is on during sending. Setting
this switch to "1" enables direct sending without
capture.
Setting this switch to "0" masks the direct
sending function on the operation panel so
direct sending with ScanRouter cannot be
selected.
3 Action when the external
handset goes off-hook
0: Manual TX and RX operation
1: Memory TX and RX
operation (the display remains
the same)
0: Manual TX is possible while the external
handset is off-hook. However, manual TX
during handset off-hook may not be sent to a
correct direction. Manual TX is not possible.
1: The display stays in standby mode even
when the external handset is used, so that
other people can use the machine for memory
TX operation. Note that manual TX and RX are
not possible with this setting.
4-7 Not used Do not change these settings.