Ricoh FAX7000L, Field Service Manual

Page: 108 / 377

SCU Bit Switch 07
BIT FUNCTION
DATA COMMENTS
0
Default transmis- 0: Memory This bit determines which setting the machine returns to when
sion mode 1: Non-memory (imme- power is switched off/on, and when returning to standby at
diate) the end of transmission. In memory mode, the message is al-
ways stored to the hard disk before transmission. In non-
memory mode, it is never stored.
1 Stamp default set-
0: Disabled
If this bit is 1, the stamp will be enabled when power is
ting 1: Enabled switched on, and every page scanned successfully (memory
mode) or sent successfully (non-memory mode) will have a
small red circle stamped on it. For each transmission, the
stamp can be switched on/off with a user option setting, but
after scanning/transmission, the setting will always return to
the default specified by this bit.
2 Transmission
0: Off 1: On
If this bit is 1, the user must enter a department code to gain
restriction by access to the machine. The code must have been
department code programmed in advance with Function 96.
3
Free polling
0: Enabled
In free polling, polling can take place even if Polling ID codes
1: Disabled of the communicating machines do not match. If this bit is 1,
free polling cannot be used.
Continued on the next page
2-56