Ricoh FAX7000L, Field Service Manual

Page: 63 / 377

No Function
Details
88
93
94
95
96
Programming the
reception mode and
telephone line type
Programming the
heater on/off timer
Switching the heater
on/off
Adjusting the speaker
volume
Programming depart-
ment codes
See page 1-33 for details.
This timer controls the on/off timing of the fusing lamp. The user
can keep the fusing lamp off when absent; received faxes will be
kept on the hard disk. The timer can be programmed differently for
each day of the week. Type in the required on and off times for
each day. Press # to change from AM to PM, or from PM to AM.
Press the up arrow on the scroll key to change the day.
After entering this mode, the status of the fusing lamp is changed.
This can be used to switch the fusing lamp on to print an urgent
message in the middle of the night. If the printer is idle for five
minutes at any time after using Function 94 to switch the lamp on,
the lamp switches off automatically, or the user can use Function
94 to switch the fusing lamp back off again.
First adjust the transmission mode monitor - use the left and right
arrows of the scroll key to adjust the volume, and to check the
volume, press Start. Press Yes to store the volume. Then repeat
the procedure for the voice message monitor.
Enter the department code that you wish to register, then press
Yes. Type in the department name, then press Yes.
2-11