33
9. Commissioning
a) Removing the Car Body
The vehicle body is secured with holding clips which must be pulled out from the retaining pins. The vehicle body can
then be lifted off.
b) Taking the Transmitter into Operation
Open the transmitter’s battery compartment (14) and insert batteries or fully charged rechargeable batteries. Observe
correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment again.
With the on/off switch (3) you can switch on the transmitter.
Check the functions at the transmitter.
c) Inserting the Batteries/Rechargeable Batteries into the Vehicle
First switch off the speed controller (switch position at the rear
end of the vehicle, see figure on the right).
A metal retention bracket is attached above each holder on the
left and right of the vehicle; it can be removed easily.
Then insert either 4 batteries or 4 NiMH batteries type AAA/
micro into the two holders at the left and right of the vehicle.
Observe correct polarity (plus/+ and minus/-), see label on the
battery compartment.
The cloth strips must be below the batteries; they make it easy
to remove the batteries/rechargeable batteries from the holder
later.
Attach the retention bracket to the two holders again to fasten
the batteries/rechargeable batteries.
