35
¨
¨
The following figures are only to illustrate the functions and do not necessarily correspond to the design of the trans-
mitter provided!
1. Release lever (= neutral position): Vehicle rolls out or doe snot move (if required, correct trimming at the transmit-
ter with the rocker button “DT2” (13))
2. Driving forwards: Pull the lever towards the handle
3. Driving backwards: Push the lever away from the handle
Stop driving immediately if the vehicle shows any unusual responses to the remote commands or if the
vehicle does not respond at all.
This behaviour may be caused by low batteries/rechargeable batteries in the vehicle or transmitter or by
too great a distance between vehicle and transmitter.
Interferences on the radio channel used (e.g. other models, radio transmissions from other devices) or
adverse transmission/reception conditions may also be a cause for unusual responses of the vehicle.
Since the receiver is supplied with power through the speed controller BEC and thus through the batteries/
rechargeable batteries in the vehicle, low or empty batteries/rechargeable batteries in the vehicle will
cause unintentional movement of the vehicle (e.g. twitching of the steering servos, etc.). For example, the
voltage at the batteries/rechargeable batteries decreases for a short time under full throttle, so that the
receiver will no longer receive the required operating voltage. The vehicle will speed up, but the two
steering servos do not react properly. Stop operating the vehicle at once and use new batteries or fully
charged rechargeable batteries.
Before the next drive, however, wait for at least 5 minutes until motor and speed controller have cooled
down sufficiently.
