background image

Modzilla

1

Safety Precautions:
Warning: Do not modify or alter this unit.

 Changes or modifi cations to this unit not expressly approved by the party responsible for compliance could void the user’s 

authority to operate the equipment.

•  This vehicle is suitable for indoor or outdoor use in 

dry conditions.

•  The vehicle is suitable for ages 14 and above. Parents 

should supervise children who operate the vehicle.

•  Remove batteries from the transmitter when not in use.

•  Switch off the vehicle and disconnect the battery 

when it is not in use.

•  Keep hands, face and loose clothing away from the 

vehicle.

•  Keep these instructions for future reference.

•  Always keep an eye on the vehicle. Careless or 

irresponsible use may cause damage.

•  Always follow these instructions when operating this 

vehicle.

•  Do not operate near people, animals or water. 

Battery Requirements for Transmitter:

3 x 1.5V AA size batteries (included)

Care and Maintenance:

•  Regularly examine all parts for damage. If any is found, 

do not use again until the damage has been repaired.

•  Use a clean cloth to wipe the vehicle clean.
•  Keep the vehicle and batteries away from direct 

sunlight and/or heat sources.

Battery Cautions:

•  Parental guidance is recommended when installing or 

replacing batteries.

•  For best performance, use new alkaline batteries in 

transmitter.

•  Insert new batteries in the transmitter as soon as any 

function becomes diminished.

•  Do not power transmitter by mixing different types of 

batteries, or old and new batteries.

•  Use only batteries of the same or equivalent type as 

those recommended.

The vehicle is equipped with a LiPo battery. Always 
follow these safety instructions:

•  ALWAYS disconnect the battery from the vehicle when 

not in use.

•  Only use the included charger.
•  Do not attempt to use this charger with NiCd or NiMH 

battery packs.

•  Do not attempt to use a damaged battery.
•  LiPo batteries must be recycled or disposed of properly.
•  Do not leave the charger unattended while charging. 

Disconnect the battery and unplug the charger 
immediately if either becomes hot! However, it is 
normal for the charger to get warm.

•  Disconnect the battery from the charger and carefully 

move the battery to a fi reproof location if the battery 

begins to swell or smoke!

•  Never allow the battery temperature to exceed 140° 

F [60° C].

•  Do not attempt to charge a battery if it is swollen or hot.
•  Do not place the charger or any battery on a fl ammable 

surface or near combustible materials while in use.

•  Never disassemble or modify pack wiring in any way 

or puncture cells.

•  Never charge inside a vehicle.
•  Always disconnect the battery and remove the charger 

from the USB port when not in use.

•  ALWAYS keep a supply of sand accessible when 

charging. Dumping sand on the battery will extinguish 
a LiPo chemical fi re.

•  ALWAYS KEEP OUT OF REACH OF CHILDREN

90 DAY LIMITED WARRANTY 

PLEASE DO NOT RETURN YOUR PRODUCT TO THE STORE 

– Revell will repair or replace factory defects for 90 days from the date of purchase. This warranty specifi cally does not 

cover crash damage, misuse or abuse. To make a warranty claim, please contact our product support team at 1-217-398-8970 or e-mail us at [email protected].

If requested by Product Support, please send defective product to: Hobby Services, 3002 N Apollo Dr., Suite #1, Champaign, IL 61822.

This warranty applies only if the product is operated in compliance with the instructions and warnings provided with each model. Revell assumes no liability except for 
the exclusive remedy or repair of parts as specifi ed above. Revell shall not be liable for consequential or incidental damages. Some states do not allow the exclusion of 
consequential or incidental damages so the above exclusion may not apply to you. This warranty gives you specifi c legal rights and you may also have other rights which vary 
from state to state.

Contents

This device complies with part 15 of the FCC rules. Operation is subject to the 
following two conditions.
 (1) This device may not cause harmful interference.
 (2)  This device must accept any interference received, including interference 

that may cause undesired operation.

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV 
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.

Any changes or modifi cations not expressly approved by the party responsible for 
compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an 
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 
20cm between the radiator (transmitter) and your body.
This transmitter must not be co-located or operating in conjunction with any 
other antenna or transmitter.

FCC REQUIREMENT

Radio Controlled Truck

Radio Controlled Truck

Transmitter

AA Batteries

Charger

Battery

Summary of Contents for modzilla mt

Page 1: ...a battery if it is swollen or hot Do not place the charger or any battery on a flammable surface or near combustible materials while in use Never disassemble or modify pack wiring in any way or puncture cells Never charge inside a vehicle Always disconnect the battery and remove the charger from the USB port when not in use ALWAYS keep a supply of sand accessible when charging Dumping sand on the ...

Page 2: ...ansmitter Parts 1 Slide the battery cover from the bottom of the transmitter 2 Insert 3 1 5V AA batteries following the polarity information 3 Re install the battery cover Insert Batteries into the Transmitter ESC Switch Motor LiPo Battery LiPo Battery Connector ...

Page 3: ... in the battery 3 Disconnect the battery from the charger and reconnect the battery to the speed control 2 The charging process takes approximately 3 5 hours For safety reasons never charge the battery for longer than 4 hours While charging the red charger LED will be on When the battery is finished the green charger LED will be on 1 Switch off the car 2 Carefully plug the charger into the USB por...

Page 4: ...tery Problem Transmitter LED flashing slowly low voltage Solution Replace the transmitter batteries REVELL INC 1850 HOWARD ST UNIT A ELK GROVE VILLAGE IL 60007 U S A MADE IN SHANGHAI CHINA PLEASE RETAIN PACKAGING FOR FUTURE REFERENCE CONTENTS AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE 2015 REVELL INC A SUBSIDIARY OF HOBBICO INC Steering Trim Driving Tips Driving the Vehicle continued Run ...

Reviews: