RANS S-20 RAVEN
TEXT MANUAL
09/01/2013
03J-01
ROTAX 912ULS - ENGINE ELECTRICAL
(FINAL INSTALL OF ENGINE)
•
Due to the wide selection of switches, circuit breakers, connectors,
gauges, flight systems, etc, which may be used by S-20 RAVEN
builders, RANS does not supply these items with the kit.
•
Electrical wiring can be aided with the use of Buss Bars for Master,
Ground and Avionic power.
1.
Refer to the parts catalog and select the required components for
assembly.
2.
Connect one Universal Cable from the POSITIVE (+) side of Battery to
Solenoid post.
NOTE: Other wires in the Electrical System will also attach
to this Solenoid post.
3.
Route one Universal Cable from grounding lug on AFT end of Starter
housing to the NEGATIVE (-) side of Battery.
IMPORTANT: Do NOT
attach the ground cable to the battery until all wiring is complete and you
are ready to start the engine.
4.
Connect one Universal Cable from un-used terminal on Solenoid to
threaded post on Starter.
5.
Refer to
FIGURE 03A-03
for Firewall Electrical Wire Pass-thru.
6.
Install the instruments, switches and breakers into the instrument panel.
Set the instrument panel in the fuselage. Referring to the parts pages
wiring schematics, Rotax installation manual, instrument manufacturer's
manuals and
FIGURE 03J-05,
wire all instruments and switches.
NOTE:
The tachometer leads are color-coded. The Tach is not affected by
switching these leads. However, it is important that the wire that attaches
to the (-) terminal also be grounded
.
