RANS S-20 RAVEN
TEXT MANUAL
04/16/2015
05H-04
21.
Temporarily bolt the upper end of the AFT Jury Strut to the Teleflex
Retainer Bracket. Slip the lower end of the AFT Jury Strut over the aft tab
of the FWD Jury Strut. Align the hole with the tab centerline. Transfer drill
#11. Use the tab on the AFT end of the Jury Strut Assembly to mark the
lower end of the AFT Jury Strut. Transfer drill using a #11 bit.
NOTE: You
may want to mark the hole location on the tab with a #11 bit and drill in a
drill press. CAUTION: Be sure the lift struts are straight before drilling.
Insert a bolt to temporarily hold in place.
22.
Slip the Aft Jury Strut off the tab. Trim Plastic Shims to match the tab. Trim
two (2) shims per tab. Align the Shims on each tab, mark and drill #11.
Install the AFT Jury Strut with Shims.
HINT: Tapering Shims will allow
easier proper fit.
23.
Disconnect the upper end of the AFT Jury Strut and modify the Flap Cable
Exit Fairing as required. Refer back to
FIGURE 05D-19
to allow for the
Flap Teleflex Cable, and the AFT Jury Strut. Also, drill a # 30 hole at the
lowest point of the Fairing as a drain.
24.
Slide the Fairing on the AFT jury strut and bolt the upper end of the AFT
Jury Strut and the Flap Teleflex Cable in place. Secure the Fairing to the
underlying reinforcement using the supplied small screws.
Use Loctite and
safety wire the drilled-head bolts of the Jury Struts in place. Tighten all
attachment bolts and nuts.
25.
Refer to
AILERON CABLE SYSTEM INSTALLATION - FUSELAGE
in
SECTION 2.
Connect the Aileron Cable as shown. Refer to
RIGGING
for
information about Bell Crank position and cable tension.
26.
Connect Push-Pull Tube to the Bell Crank Arm. Slide the Exit Fairing on
the Aileron Push-Pull Tube. Temporarily connect Aileron Push-Pull Tube
to the Aileron Horn. Adjust the Push-Pull Tube with the Control Stick
centered for the correct Aileron neutral position as per
RIGGING
instructions.
27.
Route the Flap Teleflex Cable inside the Fuselage. Route both Flap
Teleflex Cables aft of Station 3 down the side of the fuselage and forward
through the wire loops welded to the fuselage frame at Station 2A. Both
Teleflex Cables route forward and connect to the Flap handle. Secure
Teleflex cables mid-way up on Station 3 with Cushion Clamps.
28.
Connect the Flap Cable to the Flap Horns on the Flaps as shown in the
parts manual. For adjustment of the Flaps, refer to
RIGGING
.
29.
Fabricate the Fuel Lines to connect the Wing Fuel System to the Fuselage
Fuel System. Refer to
FUEL LINE INSTALLATION - FUSELAGE
.
30.
Refer to
FIGURE 05H-30.
Position the Wing Root Gap Seal on the under
side of the Wing so that the flange is tight against the Fuselage frame.
Use a hole finder and locate the holes in the Root Rib with the
Tinnermans. Mark and drill #30.
