RANS S-20 RAVEN
TEXT
MANUAL
09
/01/2013
05D-03
18.
The Flaps must move freely without rubbing on the Gap Seals. A minimum
clearance of 0.060” must be maintained between Gap Seal and Flap
Leading Edge. Final fit the Gap Seal by filing, sanding, or planeing until
proper clearance is obtained.
HINT: A miniature Wood Plane works great
to shave off excess material.
19.
Trim the Aileron Push-Pull Tube Exit and Flap Teleflex Cable Exit to lay
flat on the Wing. Trim out the AFT opening of the Aileron Push-Pull Tube
Exit. Refer to
FIGURE 05D-19
.
NOTE: Cutouts in the Flap Cable Exit will
be made during WING INSTALLATION
.
20.
Center the Exits on the Exit Reinforcement Rings on the Wing. Transfer
drill #40 through the dimpled locations on the Exits. Cleco as you drill.
CAUTION: Do NOT drill through or install a screw in the forward end of
the Aileron Push-Pull Tube Exit. A screw in this location which penetrates
through the fabric may cause damage to the Push-Pull Tube or potential
locking of the Aileron control.
Do
NOT
install the Exits at this time. For Exit
installation and connection of Aileron Push-Pull Tubes and Flap Cables
refer to
WING INSTALLATION
.
